IISc Bangalore · Engineering
Design and Simulation of Power conversion using open source tools
Prof. L. Umanand · 2018 · 53 free video lectures
This is a simulation oriented course. There are many power conversion topologies that are used in several applications like power supplies and power converters. These will be studied through simulation. This course emphasises learning and understanding converter topologies through the aid of open…
▶ Play on Open Lecture HallCourse page ↗
Lectures
- Getting started with NgSpice
- Refractoring the .cir
- Sub-circuits
- gschem and netlist generation
- Setting up for simulation with Octave
- Getting started with equation based simulation
- Resuming a simulation in Octave
- PV cell model - review
- PV cell characteristic - review
- PV cell - symbol and subcircuit
- Rectifier-capacitor filter - operation review
- Rectifier-capacitor filter - NgSpice simulation
- Rectifier-capacitor filter with non-idealities
- 3 phase Rectifier-capacitor filter
- Equation based simulation in Octave
- Passive power factor improvement - review
- Buck Converter - review
- Boost converter - review
- Buck-Boost converter - review
- Buck converter - NgSpice
- Boost converter - NgSpice
- Buck-boost converter - NgSpice
- Passive Power Factor Improvement - NgSpice
- Equation based simulation of converters
- Forward Converter - review
- Forward Converter simulation
- Understanding Core flux reset
- Core flux reset - simulation
- Flyback converter - review
- Flyback converter - simulation
- Pushpull converter - review
- Pushpull converter - simulation
- Half bridge converter - review
- Half bridge converter - simulation
- Full bridge converter - review
- Full bridge converter - simulation
- Close loop operation.
- Close loop with feed forward control.
- NgSpice simulation of close loop control.
- Battery charging with current control.
- Slope compensation for current control.
- NgSpice simulation of battery charging.
- Single phase PWM for single phase inverter.
- NgSpice simulation of single phase PWM.
- 2-axes theory for 3-phase systems.
- Transformations for 2 and 3 axes systems.
- Maximum power point tracking - NgSpice.
- Space vector PWM - digital.
- Space vector PWM - analog.
- SVPWM analog - NgSpice simulation.
- Induction motor model.
- Induction motor simulation in Octave.
- V/F control of induction motor - NgSpice.
From NPTEL (IITs and IISc) · CC BY-NC-SA. More from IISc Bangalore.
Open Lecture Hall is free, with no ads and no sign-up. It is not run by or connected to any university; the lectures are the universities' own free recordings, played from where they host them. About & rights