IIT Madras · Engineering

Power Management Integrated Circuits

Prof. Qadeer Ahmad Khan, Prof. Raveesh Magod · 105 free video lectures

105 video lectures. Topics: Introduction to PMIC - Part 1; Introduction to PMIC - Part 2; Linear versus Switching Regulators; Performance Parameters of Regulators; Local vs Remote Feedback, Point of Load Regulators; Kelvin Sensing, Droop Compensation; Current Regulator Applications, Introduction to…

▶ Play on Open Lecture HallCourse page ↗

Lectures

  1. Introduction to PMIC - Part 1
  2. Introduction to PMIC - Part 2
  3. Linear versus Switching Regulators
  4. Performance Parameters of Regulators
  5. Local vs Remote Feedback, Point of Load Regulators
  6. Kelvin Sensing, Droop Compensation
  7. Current Regulator Applications, Introduction to Bandgap Voltage References, PTAT and CTAT voltage
  8. Adding PTAT and CTAT Voltages
  9. Bandgap Voltage Reference Circuit, Brokaw Bandgap Circuit
  10. Sub-1-volt Bandgap Circuit
  11. Generating Multiple Reference Voltages; Applications of Linear Regulators
  12. Designing a Linear Regulator, Negative and Positive Feedback
  13. First-Order Systems, Phase Margin
  14. Closed-Loop Response of Second-Order Systems
  15. Relationship between Damping Factor and Phase Margin, Frequency Compensation, MOS Parasitic Capacitances
  16. Finding the Poles of the Error Amplifier - Part 1
  17. Finding the Poles of the Error Amplifier - Part 2
  18. Dominant Pole Frequency Compensation
  19. Dominant Pole Compensation at No-Load
  20. Dominant Pole Compensation using Miller Effect, RHP zero due to Miller Capacitor
  21. Intuitive Method of Finding the Poles, Pole Splitting after Miller Compensation
  22. Effect of RHP zero on Stability, Mitigating the Effect of RHP zero, LDO with NMOS Pass Element
  23. Output Impedance of PMOS LDO
  24. PSRR of PMOS LDO, Introduction to NMOS LDO
  25. Output Impedance & PSRR of NMOS LDO
  26. Sources of Error in Linear and Switching Regulators
  27. Offset in Amplifiers; Real Life Analogy; Static Offset Cancellation
  28. Dynamic Offset Cancellation Techniques (Chopping, Auto-zeroing)
  29. Digital LDO, Technique to Avoid Limit Cycle Oscillations in Digital LDO
  30. Hybrid LDO, Short-Circuit Protection
  31. Hiccup Mode and Foldback Current Limit
  32. Introduction to Switching Regulators
  33. volt-second Balance, Non-Idealities in the Power Stage of a Buck Converter
  34. Transformer Model of a Buck Converter, Conduction Efficiency, Efficiency of an LDO versus Efficiency of a Switching Regulator
  35. Synchronous versus Non-Synchronous Switching Regulators, PWM Control Techniques
  36. Losses in Switching Regulators (Conduction Loss, Gate-Driver Switching Loss)
  37. Dead-Time Switching Loss in DC-DC Converters
  38. Hard Switching Loss in DC DC Converters
  39. Magnetic Loss in DC-DC Converters, Relative Significance of Losses as a Function of the Load Current
  40. Output Voltage Ripple of a Buck Converter
  41. Choosing the Inductor and Capacitor for a Buck Converter
  42. CCM Vs DCM Operation in DC DC Converters
  43. CCM DCM Boundary Condition, Voltage Conversion Ratio in DCM
  44. Concept of Pulse Frequency Modulation PFM
  45. Classification of Pulse Width Modulators
  46. DC - DC Converter Control Techniques, Stability Analysis of Voltage Mode Buck Converter Part 1
  47. Stability Analysis of Voltage Mode Buck Converter Part 2
  48. Stability Analysis of Voltage Mode Buck Converter Part 3
  49. Dominant Pole Compensation (Type-I with Gm-C Architecture)
  50. Dominant Pole Compensation (Type-I with Op Amp-RC Architecture)
  51. Introduction to Type-II Compensation
  52. Type-II Compensator using Gm-C Architecture - Part 1
  53. Type-II Compensator using Gm-C Architecture - Part 2
  54. Type-II Compensator using Gm-C Architecture - Part 3
  55. Type-II Compensator using Op Amp-RC Architecture
  56. Introduction to Type-III Compensator
  57. Type-III Compensator using Op Amp-RC Architecture
  58. Simulation of DC-DC Converter with Type-III Compensator
  59. Type-III Compensator using Gm-C Architecture
  60. Feed-Forward Line Compensation, Loop Gain Compensation by Modulating Gm
  61. Designing a Buck Converter, Power Loss Budgeting
  62. Sizing Power MOSFETs
  63. Estimating Switching Losses and Choosing the Switching Frequency
  64. Choosing Inductance and Capacitance Values
  65. Choosing 'C' Depending on Factors that Limit the Load Transient Response
  66. Inductor and Capacitor Characteristics, Reducing the Effect of Capacitor ESL
  67. Gate Buffer and Non-Overlap Clock Generator in Gate-Driver Circuit
  68. Pulse-Width Modulator- Trailing Edge, Leading Edge and Dual Edge; Triangle Wave Generator
  69. Average Ramp Voltage of Single-Edge PW Modulator,Design Considerations of EA
  70. Delays Associated with PW Modulator, PFM and PSM Operation, DCM Operation using NMOS
  71. Designing a Zero-Cross Comparator, Inverter-Based Auto-Zeroed Comparator, Simulation Demo
  72. Current Mode Control- Peak, Valley, Emulated; VMC versus CMC; Sub-Harmonic Oscillation
  73. Ramp-Adaptive Slope Compensation to Avoid Current Loop Instability
  74. Non-Linear Control of DC-DC Converters, Phase-Shift between i_L and v_C
  75. Stabilising a Voltage-Mode Hysteretic Converter using R_esr, Relation between F_sw and the Hysteresis Window
  76. Hysteretic Converter - Simulation Demo
  77. Current-Mode Hysteretic Converter, Using R-C as Ripple Generator
  78. Controlling the Switching Frequency of a Hysteretic Converter, Delay in the Hysteretic Comparator
  79. Frequency and Voltage Regulation Loops in a Fixed-Frequency Hysteretic Converter
  80. Resetting the Capacitor Voltage in a Hysteretic Converter, Constant ON-Time Control
  81. Introduction to Boost Converter, RHP Zero in a Boost Converter
  82. Introduction to Buck-Boost Converter
  83. Tri-Mode Buck-Boost Converter (Buck, Buck-Boost and Boost)
  84. Boundary Conditions for Mode Transition in a Tri-Mode Buck-Boost Converter
  85. Generating Buck and Boost Duty Cycles in a Tri-Mode Buck-Boost Converter
  86. Introduction to Switched-Capacitor DC-DC Converters,Switched-Capacitor DC-DC Converter with V_o = 2*V_DD
  87. Applications of Switched-Capacitor DC-DC Converters in Open-Loop, Regulating the Output using Feedback Control
  88. H-Bridge Switched-Capacitor DC-DC Converter,SC DC-DC converter with Multiple Gain Settings
  89. Current Sensing Techniques in DC-DC Converters
  90. Analog Layout Techniques - Part 1
  91. Analog Layout Techniques - Part 2
  92. Digital Control of DC-DC Converters, ADC Architectures
  93. Digital Pulse-Width Modulator Architectures, Adaptive Compensation
  94. Limitations of Analog and Digital Controllers, Time-Based Controller for Buck Converter
  95. Time-Based Controller for Buck Converter and for LDO, Issues with Time-Based Control
  96. Multi-Phase DC-DC Converters
  97. Dynamic Voltage and Frequency Scaling, Single Inductor Multiple Output (SIMO) DC-DC Converter
  98. LCD/AMOLED Display Drivers - Part 1
  99. LCD/AMOLED Display Drivers - Part 2
  100. LCD/AMOLED Display Drivers - Part 3
  101. LED Drivers for Camera Flash
  102. Li-Ion Battery and its Charging Phases
  103. Battery Charger IC
  104. Live Session 25-02-2021
  105. Live Session 27-02-2020

From NPTEL (IITs and IISc) · CC BY-NC-SA. More from IIT Madras.

Open Lecture Hall is free, with no ads and no sign-up. It is not run by or connected to any university; the lectures are the universities' own free recordings, played from where they host them. About & rights