IIT Roorkee · Engineering

Principles of Metal Forming Technology

Prof. P. K. Jha · 40 free video lectures

The course focuses on understanding the science and technology of different forming processes. Most of the metallic objects undergo at least one of the metal forming operations, except the cast ones. Understanding basic principles of metal forming and further being applied by engineers and…

▶ Play on Open Lecture HallCourse page ↗

Lectures

  1. Introduction to Metal Forming Technology
  2. Classification of Metal Working Processes
  3. Behavior of Materials
  4. Failure of Materials
  5. Concept of stress and strain
  6. Description of stress
  7. State of stress in three dimension
  8. Description of strain
  9. Hydrostatic and deviator components of stress and strain
  10. Elastic stress strain relationships
  11. Introduction to theory of plasticity and flow curve
  12. True stress and true strain
  13. Yield criteria for ductile materials
  14. Yield locus, Octahedral shear stress and strain
  15. Plastic stress strain relationships
  16. Measures of yielding and ductility in tensile testing
  17. Instability in tension
  18. Strain rate effects on flow properties
  19. Temperature effects on flow properties
  20. Influence of various parameters on flow properties
  21. Classification of metal working processes
  22. Mechanics of metalworking and analysis methods
  23. Determination of flow stresses in metal working
  24. Hot working and cold working
  25. Metallurgical considerations in metal forming
  26. Introduction and classification of forging processes
  27. Equipments used in forging
  28. Forging in plane strain
  29. Introduction and classification of rolling processes
  30. Analysis of rolling load calculations
  31. Defects in rolled and forged products
  32. Introduction and classification of extrusion processes
  33. Analysis of extrusion processes
  34. Extrusion of tubes and pipes, extrusion defect
  35. Introduction to rod and wire drawing
  36. Analysis of wire drawing and tube drawing processes
  37. Sheet metal operations-I
  38. Sheet metal operations-II
  39. Powder metallurgy forming-I
  40. Powder metallurgy forming-II

From NPTEL (IITs and IISc) · CC BY-NC-SA. More from IIT Roorkee.

Open Lecture Hall is free, with no ads and no sign-up. It is not run by or connected to any university; the lectures are the universities' own free recordings, played from where they host them. About & rights