IIT Roorkee · Engineering
Processing of Polymers and Polymer Composites
Prof. Inderdeep Singh · 40 free video lectures
40 video lectures. Topics: Introduction to course; Engineering materials and processing techniques; Thermoplastics and thermosets; Processing of polymers; Thermoforming processes; Extrusion-I; Extrusion-II; Compression molding; Injection molding-I; injection molding-II; Transfer molding; Rotational…
▶ Play on Open Lecture HallCourse page ↗
Lectures
- Introduction to course
- Engineering materials and processing techniques
- Thermoplastics and thermosets
- Processing of polymers
- Thermoforming processes
- Extrusion-I
- Extrusion-II
- Compression molding
- Injection molding-I
- injection molding-II
- Transfer molding
- Rotational molding
- Blow molding
- Composite materials: Basic concepts
- Classification of composite materials
- Processing of polymer composites
- Hand lay-up
- Spray lay-up
- Compression molding.
- Injection molding
- Reaction injection molding
- Autoclave molding
- Resin transfer molding
- Filament winding
- Pultrusion process
- Sheet molding
- Pre-pregging and challenges in primary processing of composites
- Secondary processing of polymer composites
- Joining of polymer composites
- Adhesive joining
- Mechanical joining
- Microwave joining
- Induction and resistance welding
- Drilling of polymer matrix composites-I
- Drilling of polymer matrix composites-II
- Methods to prevent drilling induced damage
- Non-conventional drilling
- Process simulation of secondary processing
- Intelligent drilling of polymer matrix composites
- Web based tools for polymer matrix composites
From NPTEL (IITs and IISc) · CC BY-NC-SA. More from IIT Roorkee.
Open Lecture Hall is free, with no ads and no sign-up. It is not run by or connected to any university; the lectures are the universities' own free recordings, played from where they host them. About & rights